SLP Heavy Duty P-Drive Primary Clutch Puller for 600/850 Ski-Doo & Lynx models - 20-228
Shipping calculated at checkout.
- In stock, ready to ship
- Inventory on the way
This clutch puller is designed to pull even the toughest of clutches off the tapered crankshaft. Made of high-quality heat-treated material, this tool is made to last. Once primary clutch is off sled, puller can also be used to remove outer clutch assembly from center shaft to service rollers, arms, arm pins and spring. To do this thread puller into clutch until there is a 1" gap between puller head and black rubber damper. Hold the clutch by the movable sheave and hit the head of the clutch puller with a 3lb hammer which will release the outer clutch assembly from center shaft. Proudly made in the USA. SLP Clutch Puller Tips NOTE: It is highly recommended to use the SLP Clutch Holding Tool SLP #20-309 in conjunction with this clutch puller to safely hold the primary clutch from spinning while removing the clutch from the tapered shaft. The SLP Clutch Holding Tool also holds the primary clutch stationary upon re-installation to the tapered shaft. This clutch puller will work on many different models. Refer to the model specific factory service manual for the correct primary clutch removal instructions and torque specifications. If installing a SLP clutch kit, refer to the installation instructions specific to that kit or contact Starting Line Products Inc. Tech Support. *Wipe the clutch puller threads and tip clean to remove any dirt and apply clean grease to the threads and tip of clutch puller before each use. *For extremely stuck clutches, it is recommended to fill the center cavity of the primary clutch with grease before inserting the clutch puller. This will increase the force being exerted on the clutch and will hydro lock the clutch off the tapered shaft. This puller is not designed to be used with an impact driver which can cause damage to the puller, clutch and/or crank end. Puller damage from misuse or neglect is not covered under manufacturer’s warranty. Important Note: When pulling the primary clutch, it is recommended to leave the belt installed. Without the belt installed, the clutch can come loose with such force that it can fly off the machine and cause injury.